Magnetic damping tensor for instructions for use The working condition of tension rod tension device shall not be higher than the red range. In the process of working is allowed only by minor tension, not allowed by the major small. Zhang Lixu from major hours, must be adjusted in the stop condition, avoid the breakage. As in the adjustment of the developed tension fluctuation representation, first the tension scheduling rotating disc clockwise to the maximum tension, then slowly back Back to the desired tension near the re adjustment. Tension device in the device when the rotary handle is not too large force, will affect the robustness of embedded parts. To prevent the fall, will damage the ceramic element and shell. Zhang Ligan equipment must be aligned with a locking screw axis plane. Not far fetched using line with model does not match with the. The damping wheel combat in any grease. Don't do sth without authorization to open the rear cover of self scheduling. Always replace the wool circle, avoid plugging wire mouth. Passing line wheel abnormal sound or not to please promptly replaced, because the bearing is now wear. The damping wheel if rolling slip, please O ring, with alcohol cotton to wipe the damping wheel pull in this? To clear the enameled wire residue on the inside of the wax dirt. Adhere to the production area clean, long time dust piled up simple wear tension device components. The long time does not use or used for a long time after the tension and instability, please stop in when the rotary handle from childhood to big, from big to?? Repeated several times, you can restore the initial condition. If is the use of magnetic tension device with the cylinder, pressure shall not be less than 5 kg. We understand the details please visit the company's official website: www.www.pk-kicks.com Source: www.www.pk-kicks.com (reproduced please specify the reproduced source)